Electronic Regulator Wiring

Wiring Caution! Connect the cable to the connector on the body with the wiring arranged as show below. Proceed carefully, as incorrect wiring can cause damage. Further, use DC power with sufficient capacity and a low ripple.

Current signal type
Voltage signal type

Preset input type

1	Brown	Power supply
2	White	Input signal
3	Blue	GND (Common)
4	Black	Monitor Output

1	Brown	Power supply
2	White	Input signal 1
3	Blue	GND (Common)
4	Black	Input signal 2

Note: A right angle type cable is also available. The entry direction for the right angle type connector is to the left, (support side.) Never turn the connector, as it is not designed to turn.

Wiring Diagram

Current signal type	Voltage signal type

Vs: Power supply = 24VDC A: Input signal = 4 to 20mADC	Vs: Power supply = 24VDC Vin: Input signal = 0 to 5VDC

Preset input type w.c. illustration 5

Vs: Power supply = 24VDC Note: One of the preset pressures P1 through P4 is selected by the ON/OFF combination of S1 and S2.

S1	OFF	ON	OFF	ON
S2	OFF	OFF	ON	ON
Preset pressure	P1	P2	P3	P4

Note: *For safety reasons, it is recommended that one of the preset pressures be set to OMPa.

| Specifications | Dimensions | Wiring Caution |